Wohler AMP1-VS User's Guide download pdf (Page 23)

821697: AMP1-16 Series User Guide

Chapter 2 Audio and Metering

Configuring the Audio Outputs

AES and Analog Outputs

Any monitored input can be routed to any AES or analog output pair.

This powerful feature will allow de-embedded, Dolby decoded, or

other digital or analog audio to be used by other products. The audio

that is output doesn’t necessarily need to be monitored by the meters or

speakers. You can easily configure this in the AES Output Menu and

the Analog Output Menu.

The AMP1-16 Series monitors contain both AES and analog outputs.

The sources of these outputs are set using the AES Output

Configuration Menu

and Analog Output Configuration Menu.

The parameters that these menus adjust are as follows:

1. You can map either or both of these output ports pair-wise either

to the channel pairs that are metered and audibly monitored, or to

a selection of the SDI and AES inputs.

2. If you map the output ports to the metered (and audibly

monitored) channel pairs, then you can also specify whether the

outputs should be affected by the:

A. Solo and Mute hot keys,

B. Front panel Volume control and Balance knobs, and/or

C. Insertion of a headphone in the front panel jack.

These settings are for typical use with an external surround sound

system.

3. If you map the output ports to selected sources, then you can use

them in a variety of useful roles, independent of monitoring and

metering. For example:

A. The SDI input pairs can be de-embedded into AES streams or

into analog audio.

B. The AES input pairs can be swapped pair-wise under control

of the AMP1-16 Series monitor to the AES outputs.

1 2 ... 18 19 20 21 22 23 24 25 26 27 28 ... 109 110

No comments

Wohler AMP1-VS User's Guide Page 23