Wohler AMP2A-VTR User's Guide download pdf (Page 49)

821030: AMPx-S8 Series User Guide

Chapter 4 Presets

Methods of Accessing the Presets

Enabling/Disabling Preset Mode

To enable or disable Preset mode:

1. Press Fn+Setup.

2. Use the Up and Down arrow buttons until PSet Mode appears in

the LCD window and press Enter.

3. Press the Up and Down arrow buttons to toggle between Disa

(disabled) and Ena (enabled). Press Enter to accept the new

setting, or press Escape to cancel the change. Either way, you will

be returned to the Setup menu.

4. Press Escape again to return to normal operation.

Recalling a Preset

If Preset mode is enabled, press Input to recall the first available

preset. Subsequent presses will cycle through all the available presets.

Speaker Assign/Preset Buttons (Presets 1 through

4 Only)

Presets 1 through 4 get special attention. You can recall, save, or

overwrite them simply by pressing Fn+Preset x (where x represents

the corresponding

Speaker Assign button immediately above or

below the meters on the left side of the unit). In the following examples,

we’ll be using Preset 1.

Note:

When this mode is enabled, you can no longer directly select

the inputs by the input type (e.g., AES 1, SDI 2, analog, and

so on). The inputs are accessed only indirectly through the

presets in this mode. To access the inputs by input type, you

must first disable Preset mode.

Note:

This selection will not appear if all the presets are

empty. In this case, you will need to store at least one

preset to enable this menu item.

1 2 ... 44 45 46 47 48 49 50 51 52 53 54 ... 73 74

No comments

Wohler AMP2A-VTR User's Guide Page 49