Wohler AMP2A-VTR User's Guide download pdf (Page 61)

821030: AMPx-S8 Series User Guide

Chapter 5 Setup Menu

Preset Mode

For more information about presets Refer to Chapter 5: Setup Menu on

page 43.

To enable or disable Preset mode:

1. Press Fn+Setup.

2. Use the Up and Down arrow buttons until PSet Mode appears in

the LCD window and press Enter.

3. Press the Up and Down arrow buttons to toggle between Disa

(disabled) and Ena (enabled). Press Enter to accept the new

setting, or press Escape to cancel the change. Either way, you will

be returned to the Setup menu.

4. Press Escape again to return to normal operation.

Erasing a Preset

This menu command allows you to erase a stored preset. Pressing the

Enter button will allow the user to choose a preset to erase.

Figure 5–10 Erasing a Preset - Choose the Preset

Number

The Left and Right buttons select from among the available presets.

Once you press the

Enter button to select a preset, the system will

warn you that the preset will be erased.

Note:

This selection will not appear if all the presets are

empty. In this case, you will need to store at least one

preset to enable this menu item.

Note:

If the unit does not have any stored presets, this menu item

will not appear.

Choose PresetNum

Preset1: Off Air

1 2 ... 56 57 58 59 60 61 62 63 64 65 66 ... 73 74

No comments

Wohler AMP2A-VTR User's Guide Page 61