Wohler AMP2-DA User's Guide download pdf (Page 18)

821016: AMPx-E8 Series User Guide

Chapter 1 Installation

Installation

Power

The unit comes with a standard 24VDC/3.0 A internal power supply

and connects an A/C mains power source (65W, 100 to 240 VAC, 50/

60Hz) through the IEC connector provided on the rear panel of the unit.

When the mains plug or appliance coupler is used as the disconnect

device, the disconnect device should remain operable.

Installation

Initial Setup

1. Carefully install the monitor into a standard 19”-rack.

2. Connect all signal cables to and from associated equipment.

3. Connect the power cord from the monitor to A/C mains.

Power Up

The AMPx-E8 Series monitors are factory-configured so that all settings

are non-volatile. When power to the unit is cycled (off/on), the unit will

restore itself so that each setting such as channel selection(s), input

type, and so on, are automatically restored to the unit’s previous

factory setting. However, you can custom configure the monitor to

automatically restore your configuration settings on power up. Refer to

Setup Menu on page 55 for details.

1 2 ... 13 14 15 16 17 18 19 20 21 22 23 ... 89 90

No comments

Wohler AMP2-DA User's Guide Page 18