Wohler AMP2-DA User's Guide download pdf (Page 72)

821016: AMPx-E8 Series User Guide

Chapter 6 Setup Menu

Saving a Preset

Creating a New Preset

1. Press either the Up or Down buttons to choose any preset labeled

Unused.

Figure 6–4 Choose an Unused Preset

2. Press the Enter button to display a prompt for a new preset name

as shown in Figure 6–5.

Figure 6–5 Assigning the Name of a Preset

3. Scroll through letters (and symbols) using the Left and Right

buttons. Press the Enter button to accept the current letter shown

in the display and move to the next letter. Repeat this procedure

until the display shows the name you want to use for this preset.

Figure 6–6 Completed Preset Name Selection

Note:

To cancel the procedure at any time during this process,

press the Escape button and the preset will not be saved

and the unit will return to normal operation.

Choose PresetNum

Preset7: Unused

AES 1 ?@<A>BC

Name: A_

Note:

Pressing the Enter button may display multiple letters,

but the only one that changes will be the one

immediately to the left of the underscore. As a result, it

may be necessary to start the procedure over again if

too many characters appear in the display.

HD.SDI1 _DONE_

Name: HDSDI1

_

1 2 ... 67 68 69 70 71 72 73 74 75 76 77 ... 89 90

No comments

Wohler AMP2-DA User's Guide Page 72