Wohler AMP2-DA User's Guide download pdf (Page 26)

821016: AMPx-E8 Series User Guide

Chapter 2 System Overview

Rear Panel Connectors

• Analog In (DB-25-F): This connector accepts balanced, low

impedance, line level analog signals. See Figure 2–7 below for pin-

out information.

Figure 2–7 Analog Input Connector Pin-Out

Input Connectors

• Power: Attach a standard IEC-320 power cord between this

connector and AC mains power.

• AES/PCM In (1 through 4, BNC-F): These connectors accept

unbalanced (75 ) PCM (AES/EBU) formatted signals. These inputs

appear as AES1 in the LCD screen.

If you are not connecting downstream equipment, then you should

terminate the selected input connector. Otherwise, unterminate

them.

• AES/PCM In (and Loop Out) (DB-25-F): This connector accepts

balanced (110 ) AES signals. Inputs are internally connected to the

loop-through outputs. These inputs are referred to as AES2 in the

LCD screen. If you are connecting downstream equipment to the

AES loop-through outputs of this connector, then you should

unterminate this connector. If you are not connecting downstream

equipment, then you should terminate them. Refer to Terminating/

Unterminating Inputs on page 40 for details.

Note:

The pin-out for this connector is compatible with

Tascam DB-25 to XLR cable assemblies. Contact your

Wohler sales representative for availability. (Wohler’s

contact information is on page ii of this document.)

1 2 ... 21 22 23 24 25 26 27 28 29 30 31 ... 89 90

No comments

Wohler AMP2-DA User's Guide Page 26