Wohler AMP2-DA User's Guide download pdf (Page 62)

821016: AMPx-E8 Series User Guide

Chapter 5 Dolby

Dolby Input Source Selection

1. Enter Dolby Decode mode by pressing the Dolby button.

2. Press the Input button to select the source. (The selection is

enabled when it appears in the LCD screen.) Each press of the

Input button cycles through each of the four selections:

• BSt1 (Bitstream 1)

• BSt2 (Bitstream 2)

• SDI (not available in the DA model)

• Auto.SDI or Auto.SDI2 if no signal is present

• SD.SDI (signal is present and auto-detected)

• HD.SDI (signal is present and auto-detected)

• 3G.SDI (signal is present and auto-detected)

3. If one of the SDI inputs is selected, pressing the

Group button

selects the de-embedded SDI pair to be decoded.

Figure 5–1 Dolby Input Source Selection

Dolby Decoding

When you connect a valid bitstream containing at least one multi-

channel program (such as a 5.1 or 7.1 channel surround type) to the

AMPx-E8 Series unit, it enters a default multi-purpose monitoring

mode, the Auto-Monitor Multi-Channel Mode. While this mode initially

sends a downmix to the unit's speakers, this mode also allows you to

select pairs of channels from the multi-channel program in a Dolby

bitstream.

PG1 BSt1 PG1

Note:

You can only enter this mode as described below; it cannot

be selected.

1 2 ... 57 58 59 60 61 62 63 64 65 66 67 ... 89 90

No comments

Wohler AMP2-DA User's Guide Page 62