Wohler AMP2-DA User's Guide download pdf (Page 52)

821016: AMPx-E8 Series User Guide

Chapter 3 Audio Configuration

Terminating/Unterminating Inputs

Each of the AES and bitstream inputs on the AMPx-E8 may be

terminated or unterminated independently of each other. A given input

should be terminated when the AMPx-E8 is the last receiving device in

the signal path or is the only receiving device in the signal path. If the

signal loops through the AMPx-E8 to another receiving device, the

input should be unterminated in the AMPx-E8 (and terminated at the

last device in the signal path). Terminating the signals properly

improves signal integrity, and ensures the signal will be received

correctly by all the devices in the signal chain.

In the AMPx-E8 monitors, the terminations are set to “Enabled” by

default for all inputs.

To change the termination settings:

1. Hold the Fn button while pressing the Setup button.

2. Press the Down button once. The LCD should look similar to the

image in Figure 3–14 below.

Figure 3–14 AES Termination Settings

3. Press the

Enter key. The LCD should now look like the image

Figure 3–15 or in Figure 3–16.

Figure 3–15 Termination Setting Currently Enabled

Figure 3–16 Termination Setting Currently Disabled

848131 2.00

Setup: Aes Term

AES Termination

Unbal. 1: Ena

AES Termination

Unbal. 1: Disa

1 2 ... 47 48 49 50 51 52 53 54 55 56 57 ... 89 90

No comments

Wohler AMP2-DA User's Guide Page 52