Wohler AMP2-DA User's Guide download pdf (Page 74)

821016: AMPx-E8 Series User Guide

Chapter 6 Setup Menu

Saving a Preset

3. Pressing the Enter button keeps the old name for the new preset

and returns the unit to normal operation.

Pressing the

Escape button displays a prompt for a new preset

name as shown in Figure 6–9 below.

Figure 6–9 Save New Name?

4. Scroll through letters (and symbols) using the Left and Right

buttons. Press the Enter button to accept the current letter shown

in the display and move to the next letter. Repeat this procedure

until the display shows the name you want to use for this preset.

Naming will automatically end after you select eight characters, or

when you press the Enter button when _DONE_ appears on the

display.

After naming the preset, the current state of the system is saved

under that name and preset number, and the system returns to

normal operation.

Important:

This concludes the procedure for overwriting an existing preset with

the same name.

Studio ?@<A>BC

Name: A_

Note:

Pressing the Enter button may display multiple letters,

but the only one that changes will be the one

immediately to the left of the underscore. As a result, it

may be necessary to start the procedure over again if

too many characters appear in the display.

Note:

The _DONE_ selection comes before the numerals, and

follows the lower case alphabet. The character order is

the order of ASCII characters.

Important:

This concludes the procedure for overwriting an existing preset with a

new name.

1 2 ... 69 70 71 72 73 74 75 76 77 78 79 ... 89 90

No comments

Wohler AMP2-DA User's Guide Page 74