Wohler AMP2-DA User's Guide download pdf (Page 47)

821016: AMPx-E8 Series User Guide

Chapter 3 Audio Configuration

SDI Inputs

• Right (+): Selected channels are in-phase (+1 correlation

maximum).

With typical stereo program material, the moving block display is

normal.

If the signals to the speakers are completely independent, they will

have a correlation result of 0, and the block will be stationary in the

center of the screen. See Figure 3–10 below for an example.

Figure 3–10 Phase Correlation Display

A mono in-phase signal fed to both right and left speakers would

result in the block being in the right-most position indicating the left

and right speaker signals are phase-identical.

2. Press any button to return to normal operation.

SDI Inputs

Selecting SDI Groups and Su/jointfilesconvert/392398/bgroups

Dolby Decode Mode Disabled

When you select either of the SDI inputs for monitoring while Dolby

Decode mode is disabled, the Group button allows you to select which

two, four-channel SDI audio groups to display in the level meters.

When you press the buttons quickly, the selection order follows that

shown in Table 3–3 on page 36.

- Phase +

1 2 ... 42 43 44 45 46 47 48 49 50 51 52 ... 89 90

No comments

Wohler AMP2-DA User's Guide Page 47