Wohler AMP2-DA User's Guide download pdf (Page 70)

821016: AMPx-E8 Series User Guide

Chapter 6 Setup Menu

Analog Output Preference Mode

To exit Setup Mode, press the Esc button.

Analog Output Preference Mode

To change the Analog Output Preference, select AOutputPref and

then press the Enter button.

This entry within the Setup menu is used to determine how the

Selected/Downmix Analog Out and Metered Analog Out

connectors on the rear panel output the metered signal when any of the

DM1, DM2, or DM3 downmix selections is enabled.

The default setting is Downmix, which outputs the speaker assign with

individual channel scaling (gain settings) intact as determined by the

selected downmix (DM1, DM2, or DM3). In addition, the channels are

summed at unity gain into the speakers and headphones. However, if

Discrete is selected, then all channels within the downmix are output

from these connectors at unity gain without scaling of the channels as

determined by the selected downmix. For example, the center channel

scaling is -3dB, and the surround channel scaling is set in the Setup

menu.

Recalling a Preset

1. Press the Fn + Setup button to display the Setup menu.

2. Press the Up button to display RCallPSet.

3. Press the

Enter button to select this option.

Note:

The RCallSet, PSetMode, and ErasePSet options will

not be available if a preset has not been previously saved to

the unit. See Saving a Preset on page 59 for how to save a

preset of the current unit configuration.

1 2 ... 65 66 67 68 69 70 71 72 73 74 75 ... 89 90

No comments

Wohler AMP2-DA User's Guide Page 70