Wohler AMP2-DA User's Guide download pdf (Page 48)

821016: AMPx-E8 Series User Guide

Chapter 3 Audio Configuration

SDI Inputs

1. Press the Group button quickly to select the group and then wait

until the display flashes once.

2. Now press the Group button more slowly to toggle between

Group 1/2 and Group 3/4 selections.

After this, rapid presses will again initiate the cycling as shown in

Table 3–3. Since the first two selections are more common choices,

this features allows easy toggling between them.

Dolby Decode Mode Enabled

When you select either of the SDI inputs for monitoring when Dolby

Decode

mode is enabled, the Group button allows you to select the SDI

sub-group (two channels) to send to the Dolby decoder. You can select

either of the two available sub-groups within any of the SDI audio

Groups 1, 2, 3, or 4.

The embedded channels within an SDI signal are defined in Table 3–4

below.

Table 3–3 SDI Group Select

Button

Press

Left Bar Graph Bank

(1 through 4)

Right Bar Graph Bank

(5 through 8)

1st Group 1 Group 2

2nd Group 3 Group 4

3rd Group 1 Group 2

4th Group 1 Group 3

5th Group 1 Group 4

6th Group 2 Group 3

7th Group 2 Group 4

8th Group 3 Group 4

Table 3–4 SDI Group Definitions

SDI Group SDI Sub-Group Channels Designation

Group 1

Sub-Group 1 1 and 2 G1

1/2

Sub-Group 2 3 and 4 G13/4

Group 2

Sub-Group 1 1 and 2 G21/2

Sub-Group 2 3 and 4 G23/4

Group 3

Sub-Group 1 1 and 2 G3

1/2

Sub-Group 2 3 and 4 G33/4

Group 4

Sub-Group 1 1 and 2 G4

1/2

Sub-Group 2 3 and 4 G43/4

1 2 ... 43 44 45 46 47 48 49 50 51 52 53 ... 89 90

Comments to this Manuals

No comments

Wohler AMP2-DA User's Guide Page 48

Comments to this Manuals

Related products and manuals for Soundbar speakers Wohler AMP2-DA